About product

It is Intended to regulate various technological processes duration and sequence according to a given control program.

General characteristics

There are two device types

  • type 1 - (with solenoid) with remote start and automatic shutdown at the end of the cycle;
  • type 2 - (without solenoid) in the mode of continuously repeating cycles until forced stopping.

Device type 1

The device type 1, depending on the version provides a electrical and pneumatic control circuits combination/

Type I

А

Б

В

Control circuits number

electric

11

5

3

pneumatic

0

6

8



To start a new cycle, an outside command must be submitted.

Device type II

Device type II, depending on the version, provides a combination of electric and pneumatic control circuits.


Type II

Г

Д

Е

Control circuits number

electric

12

8

6

pneumatic

0

4

6


The change magnitude in the cycles duration shall not exceed ± 2.5% of the nominal values of the cycles duration indicated in the table.

The cams number installed by the consumer in each camshaft groove should not exceed 4. The number of cams mounted on the shaft for simultaneous actuation should not exceed;
for triggered - 6; for cocking - 4.

The electrical contacts of the control circuits must withstand, without stripping and adjusting, 200,000 operations, with a breaking power of 500 W of active load or no more than 150 VA of inductive load.

Additional information

  • The time spent by the solenoid under voltage should not exceed 10 s.
  • The total number of different working cycles (shaft speeds) is 163. The maximum number of commands per cycle is 96.
  • Power supply from AC mains with voltage of 220 V;
  • Power consumption 35 W
  • The limits of measuring the duration of operating cycles from 30 s to 18 h.
  • Overall dimensions 311 x 283 x 127 mm
  • The mass of the device is not more than 8.8 kg.